Tidy Up the Toys

 I found this to be one of easiest challenges as the attachment I used had been been made previously. We decided not to do this challenge Autonomously as it would have taken a lot more time which we didn't have because I had my GCSEs and having to do everything over zoom and email slowed everything down. However, I think doing it by remote control, whilst meaning we get fewer points, I do still think it was a very effective way of doing it.

Video - https://youtu.be/GuJnDeJ1pFw

(James)

Comments

Post a Comment

Popular posts from this blog

Introduction form Steve

 I think it was back in February 2018 when  James  turned up at Leicester Hackspace along with his mother and sister with an interest in building a robot and learning some electronics and software. That summer he successfully applied for PIWARS 2019, now we just had to build a robot. Our first entry, team RATAE, was based on hardware that James already possessed, a PI0W, Pimoroni Explorer Hat and a PI Supply Controller. So James set-to designing the chassis and I said I would help with the software. We did not realise it at the start, but we were effectively building the Tiny 4WD robot. The first chassis was built out of Mecanno . Documentation on the PI Supply website led us to “Approximate Engineering’s Python Game Controller”. This is going to be simple I thought, as the software for controlling the robot was already done, I just had to interface to my Je-Vois camera, add some line following sensors and we would be started,famous last words.   James would have n...
Read more

Feed the Fish Challenge

I found this challenge very difficult as I wasn't sure how to get the nerf bullets in the top, because they would always either go straight over or hit the container.  I decided to try and raise my nerf gun attachment up so I could just point the gun into the top and drop the bullet in, however when I did this I hadn't read the rules well enough to realise there was a height limit. This resulted in me realising that the attachment was 170mm too high, although it did work very effectively (video of the mechanism in action - https://youtu.be/7mnbfLNHEIY)! Another problem was that it was slightly too wide. Although I did find a solution to this it didn't matter because we couldn't get the attachment below the height limit. I then tried to modify my original design to allow the nerf gun to fire straight up. However, this didn't give me enough accuracy and I couldn't find any other way to fire into the top within the rules. This meant I ended up just pushing golf bal...
Read more